Use of Aerated Lagoons

-

 An aerated lagoon is a suspended-growth process in waste water treatment unit. The aerated lagoon water treatment system consists of a large earthen lagoon or basin that is equipped with mechanical aerators to maintain an aerobic environment and to prevent settling of the suspend biomass. It is provided with inlet at one end and outlet at the other end to enable the wastewater to flow through and to retain for the specified detention time. Initially, the population of microorganisms in an aerated lagoon is much lower than that in an ASP because there is no sludge recycle. Therefore, a significantly longer residence time is required to achieve the same effluent quality. However, this longer residence time may be an advantage when complex organic chemicals are to be degraded. Also, the microorganisms in aerated lagoons are more resistant to process upsets caused by feed variations than those in ASP because of the larger tank volumes and longer residence times used. The major difference between the ASP and aerated lagoons is that in the latter settling tanks and sludge recirculation arrangements are absent. The aerated lagoons water treatment may be provided with maturation pond for further treatment of effluent as shown below.

Aerated Lagoon 

Suspended Growth Aerated lagoons

Suspended growth aerated lagoons are relatively shallow earthen basins of depth varying from 2 to 5 m provided with mechanical aerators on floats or fixed platforms. Mechanical aerators are used to provide oxygen for biological treatment of wastewater as well as keep the biological solids in suspension. They are fully aerobic from top to bottom as the aeration power input is sufficiently high to keep the solids in suspension with complete mixing. No settlement occurs in such lagoons and under equilibrium conditions the new (microbial) solids produced in the system equal to the solids leaving the system. Thus, the solids concentration in the effluent is relatively high and some further treatment is generally provided after such lagoon.

Because of a suspended growth system of a complete mix reactor without recycle, the basis of design is SRT, which is equal to HRT under ideal flow condition. Typical design values of SRT for aerated lagoons used for treating domestic wastewater vary from 3 to 6 days

Facultative Aerated Lagoon

In facultative aerated lagoon water treatment, some solids leave along with the effluent stream and some settle down in the lagoon since aeration power is sufficient for oxygenation and not for keeping solids in suspension. As the lower part of such lagoons may be anaerobic while the upper layers are aerobic, the term facultative is attached to the aerated lagoon. Facultative aerated lagoons have been more commonly used the world over because of their simplicity in operation and minimum need of machinery. They are often referred to simply as aerated lagoon. Much less land is required compared to oxidation ponds. Facultative aerated lagoons can provide 70 – 80% BOD removal from readily degradable wastes such as domestic sewage.

MIXING

Mixing of water is beneficial from several points of view. Without mixing thermo stratification will occur, thereby permitting the retention of undisturbed surface layers for relatively long periods of time. Such conditions provide an excellent environment for algae to become established and grow. Mixing will also exhaust the carbon dioxide from the system. At lower mixing intensities, algae will grow provided the HRT is sufficient. Mixing is provided by the aeraters.

REFERENCE:-

https://www.thewatertreatments.com/wastewater-sewage-treatment/aerated-lagoon/

 

Comments

Post a Comment

Popular posts from this blog

SLUDGE REDUCTION POTENTIAL OF METAZOA

-
Image
 A way to reduce excess sludge production and enhance mineralization is to retain the sludge completely in a treatment plant, which can be achieved by a membrane separation process. There the sludge concentration is expected to stabilize at the level at which energy supplied is fully utilized for maintenance purpose. Another way to enhance mineralization and reduce the sludge production is to exploit the organism in the process that predate on bacteria (sludge), by promoting their growth in an extra “grazing stage”. During energy transfer from bacteria to higher trophic level organisms, energy is lost due to inefficient biomass conversion and thus the predator may make a large contribution to biomass replacement. A long sludge retention period in membrane bioreactors (MBR) is very suitable for the abundant growth of these higher organisms. This predatory population in the system can be exploited to enhance mineralization and reduce sludge production.  High metazoa density lead...
Read more

Pseudomonas in wastewater treatment

-
Image
Pseudomonas in wastewater treatment-  Source- Céline Slekovec, Julie Plantin, and Didier Hocquet  Pseudomonas is a genus of Gram-negative, Gammaproteobacteria, belonging to the family Pseudomonadaceae and containing 191 validly described species. The members of the genus demonstrate a great deal of metabolic diversity and consequently are able to colonize a wide range of niches. Pseudomonas aeruginosa was isolated consistently from domestic and hospital sewage. In domestic sewage the numbers were usually less than 30,000 per 100 ml whereas counts above 500,000 per 100 ml were frequently obtained in hospital sewage. Correspondingly high counts of Escherichia coli were not found in hospital sewage and the ratio of E. coli to P. aeruginosa was usually less than 25 compared to ratios of over 500 often found in ordinary domestic sewage. During passage through sewage treatment plants the numbers of both bacteria were reduced by about 90% so that their ratio in the effluent remained...
Read more

ANAEROBIC FERMENTATION

-
Image
  Most of the organics in the sewage sludge were transformed into useful energy by the anaerobic fermentation of microorganism. Plenty of nitrogen, phosphate, potassium could be separated from the leachate produced in this fermentation which makes the recycling of sewage sludge much easier. This method could also help stabilize and decrease the amount of sewage sludge and make it harmless.  Here is a brief account on the mechanism of this process. The sewage sludge samples are taken in conical flasks; the flasks were sealed and kept in an airtight and anaerobic condition. Then the conical flasks were kept in thermostatic water bath box, controlling the temperature at 95°C to improve the efficiency of the anaerobic fermentation of the sewage sludge. The conical flasks were taken out and put into a container with oxygen at the 2th, 7th, 10th, 14th, 17th, 21th, and 28th day after the beginning of the anaerobic fermentation, respectively. When the flasks were taken out, a little o...
Read more